Leica DMLS Bedienungsanleitung Seite 14

available for condensers CL/PH and CLP/PH. A
diffusing screen (similar to 7.7) is inserted
instead; polarized light is not possible with this
screen.
Slide with light ring or λ compensator*
Slides with light rings DF, PH to PH 3 diffusing
screen or λ compensator can be slotted into the
CL and CLP condensers from the right (7.7).
Fixing the condenser
Raise the specimen stage as far as the stop
(11.2). Lower the condenser carrier using the
drive knob (11.1, can be operated on both sides).
Remove filter holder or polarizer (11.4; 12.3) if
present.
Slightly loosen the clamp screw (10.3) so that the
condenser can be inserted from the front. The
adjustment range of the aperture diaphragm
(23.7) should face the front. Make sure the guide
pin clicks into the slot! Do not turn the clamp
screw (10.3) too tightly!
Fig. 11 Filter magazine
1 Condenser height adjustment, 2 Focusing, 3 Switching lever
with adhesive label, 4 Guide catch for clicking into stand
2 1
14
Downloaded from www.Manualslib.com
3 4
3
manuals search engine
Object guide*
Assemble using the two clamp screws. The
delivery either includes the version for 2 speci-
men slides (13.1) or the one-hand object holder
for 1 specimen slide (26 mm x 76 mm) (13.2).
A rotatable object guide (13.3) is also available.
Pol object guide and specimen clips → supple-
mentary manual for DM LSP.
Objectives
Always only use Leica objectives of tube length
∞ (infinity) with M25 thread! It is customary,
although not essential, to arrange the objectives
so that the magnification increases when the
objective nosepiece is rotated counterclock-
wise. Lower the specimen stage as far as
possible before assembling the objectives.
!
Attention:
Close vacant threads in the nosepiece with dust
protection caps (code no. → p. 47)!
Further information → p. 22 – 24.
Fig. 12 Filter holder, polarisers
1 Analyser, 2 λ or λ/4 compensator, 3 Polarizer, 4 Filter holder
1
3 2
2
3
4