Introduction; Device Description (Fig. 1-14); Scope Of Delivery - Parkside PHDB 4 C3 Bedienungs- Und Sicherheitshinweise

2. Introduction

MANUFACTURER:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
DEAR CUSTOMER,
we hope your new tool brings you much enjoyment and suc-
cess.
NOTE:
According to the applicable product liability laws, the manu-
facturer of the device does not assume liability for damages
to the product or damages caused by the product that occurs
due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, by not authorised service techni-
cians,
• Installation and replacement of non-original spare parts,
• Use other than specified.
We recommend:
Read through the complete text in the operating instructions be-
fore installing and commissioning the device.
The operating instructions are intended to help the user to be-
come familiar with the machine and take advantage of its ap-
plication possibilities in accordance with the recommendations.
The operating instructions contain important information on
how to operate the machine safely, professionally and econom-
ically, how to avoid danger, costly repairs, reduce downtimes
and how to increase reliability and service life of the machine.
In addition to the safety regulations in the operating instruc-
tions, you have to meet the applicable regulations that apply
for the operation of the machine in your country.
Keep the operating instructions package with the machine at
all times and store it in a plastic cover to protect it from dirt and
moisture. Read the instruction manual each time before operat-
ing the machine and carefully follow its information.
The machine can only be operated by persons who were in-
structed concerning the operation of the machine and who are
informed about the associated dangers. The minimum age re-
quirement must be complied with.
In addition to the safety instructions contained in this operating
manual and the specific regulations of your country, the techni-
cal rules generally accepted for the operation of machines of
the same type must be observed.
We accept no liability for damage or accidents which arise
due to non-observance of these instructions and the safety in-
formation.
22 GB/IE

3. Device description (Fig. 1-14)

1. Bow-type handle
2. Hand spray gun
3. Trigger
4. Trigger lock
5. Upper spray gun holder
6. High-pressure hose
7. Tubular frame
8. Choke lever
9. Air filter
10. Tyres
11. Jet pipe
12. Lower spray gun holder
13. Hose holder
14. Filler cap
15. Fuel tank
16. Water outlet
17. Cleaning agent tank
18. Filler cap for cleaning agent tank
19. On/Off switch
20. Rubber foot
21. Water inlet
22. High-pressure pump
23. Carburettor
24. Spark plug/Spark plug connector
25. Silencer
26. Pull starter
27. Nozzles (red, yellow, green, white, black)
28. Self-tapping screw
29. Screws M6x45
30. Washer
31. Axles
32. R-clips
33. Rubber foot
34. Nut M6
35. Nozzle cleaner needle
36. Spark plug wrench
37. Filling hose with funnel
38. Spanner
39. Screwdriver
40. Quick connector
41. Hose connection adapter
42. Oil inlet
43. Oil tank cover with oil dipstick
44. Oil drain screw

4. Scope of delivery

• Engine unit
• Wheels
• High-pressure hose
• Hand spray gun
• Jet pipe
• High-pressure nozzle, (red, yellow, green, white)
• Low-pressure nozzle / cleaning nozzle (black)
• Rubber foot
• Spark plug wrench
• Spanner
• Screwdriver
• Upper and lower spray gun holder