Setup; Operation; Before First Use - CertoClav MultiControl 12 Bedienungsanleitung

Bedienungsanleitung_MC_ALU_DE_EN_RevD.docx

Setup

Autoclave
•
Set up is easy. Either put the autoclave on a table or the floor, so that you get a convenient work
height.
•
Unpack the manometer and the steam release cock. Mount them by putting them with gaskets in the
holes and fix with nut from inside of the lid. These appliances have been packed separately to avoid
damage in transportation.
•
We recommend mounting a hose on the steam release valve, inner diameter 10 mm. (Art. no.
8582012)
•
Plug in the connection cable to the socket on the back side. Connect the other end to the
MultiControl 2 controller.
Controller
1. Connect the controller (port 4) with a heater/autoclave using connection cable.
2. Connect the controller (port 5) with mains cable to a power socket.
3. Screw in the cable of the PT100 probe (port 3).
4. Optionally connect a printer (Port 2)
5. The controller can be mounted on the wall using the holes on the side of the enclosure.

Operation

Before first use

READ INSTRUCTIONS BEFORE FIRST USE!
The first run should be without load; only with water.
CertoClav Sterilizer GmbH
Peintner Strasse 10
A-4060 Leonding / Austria
www.certoclav.com support@certoclav.com
Page 32 of 44
1) USB port for PC
2) Connection for CertoClav
protocol printer
3) Port for a 4-wire PT100
temperature sensor
4) Port for connection to a
heater or autoclave (220V,
10A max)
5) Mains connection (mains
cable) with switch and fuse
holder