Spare Parts - CertoClav MultiControl 12 Bedienungsanleitung

Bedienungsanleitung_MC_ALU_DE_EN_RevD.docx
Replacement of the lid gasket
1. Put out the old gasket and clean the groove.
2. Oil the groove and the gasket with cooking oil
3. Press gasket into groove ribbed side pointing downward (letters show to the middle of the lid) Do not
stretch the gasket when inserting, as it will get too long. Rather try to squeeze it a little bit, it will seal
better.
WE RECOMMEND THE CERTOCLAV SERVICE SET ART. No.: 1250499. It contains all spares which are under
wear and tear and must be replaced.

Spare parts

1250334 Manometer mit Schleppzeiger, komplett
1250320 Druckbegrenzungsventil
1250433 Ventildichtung
1250208 Abdampfhahn komplett mit Entlüftungsdüse
1250235 Deckelgriff mit Verriegelung, Schraube und Mutter Lid handle with lock, screw and nut
1250242 Abdampfventil
1250237 Griff mit Schraube für Gerätekammer
1251324 Sockel mit Steckdose
1250408 Dichtung für Sockel
1260404 Deckeldichtung Silikon 24 cm
1250236 Deckelgriff mit Schraube und Mutter
1250451 Dichtung für Manometer und Abdampfhahn
1250310 Sicherheitsventil mit 0-Ring
1300188A Sensorkabel mit Einschraubfühler PT100
1250335 Bimetall-Sicherung
1250356 Kabelsatz für Essential/MC
1300198 Geräteverbindungskabel zu Steuerung
1300197 Netzkabel Steuerung
1250380 Reinigungsnadel für Düse
Art. no. 1250499 Service Set 1: includes all gaskets and valves which are necessary for maintain the lid.
Gaskets should be replaced yearly. Long time cycles cause a higher wear and tear; replacements could be
necessary already after 6 months.
CertoClav Sterilizer GmbH
Peintner Strasse 10
A-4060 Leonding / Austria
www.certoclav.com support@certoclav.com
Manometer with maximum indicator
Pressure control valve
Gasket for valve
Steam release cock complete with venting
nozzle new
Steam release valve
Handle with screw for chamber
Base with socket
Gasket for base
Lid gasket Silicon 24 cm
Lid handle with screw + nut
Gasket for manometer and steam release cock
Safety valve with 0-ring
Heat probe cable with PT100
Bimetal fuse
Cable set for Essential/MC
Connection cable to controller
Main cable controller
Needle for cleaning venting nozzle
Page 35 of 44