Assembly; Battery Information; Operation - Husqvarna 115iL Bedienungsanweisung

• Remove the battery before you do maintenance,
other checks or assemble the product.
• The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
• Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
• If you do not do maintenance, it decreases the life
cycle of the product and increases the risk of
accidents.
Introduction
WARNING:
safety chapter before you assemble the
product.
To assemble the trimmer guard
1. Assemble the trimmer guard. (Fig. 31).
2. Install the bolt through the housing of the trimmer
head and the trimmer guard. (Fig. 32)
3. Tighten the bolt.
To assemble the trimmer head
1. Turn the output shaft until the hole in the drive disc
aligns with the hole in the gear housing.
2. Install the locking pin in the hole to lock the shaft.
3. Turn the trimmer head counterclockwise. (Fig. 33)
Introduction
WARNING:
safety chapter before you use the product.
Before you operate the product
• Examine the work area to make sure that you know
the type of terrain. Examine the slope of the ground
and if there are obstacles such as stones, branches
and ditches.
• Do an overhaul of the product.
• Do the safety inspections, maintenance and
servicing that are given in this manual.
• Examine the motor for dirt or cracks. Use a brush to
clean the motor from grass and leaves. Use gloves
when it is necessary.
• Examine the trimmer head and cutting attachment
guard for damages or cracks. Replace the trimmer
14

Assembly

Read and understand the

Operation

Read and understand the
• Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
• Only use original spare parts.
To assemble the loop handle
1. Install the screw into the loop handle. (Fig. 34)
2. Assemble the loop handle to the attachment on the
shaft.
3. Tighten the screws.
4. Adjust the loop handle to a correct position. Refer to
To adjust the loop handle and telescopic shaft on
page 15 .
To assemble the plant guard
1. Install the plant guard into the holes on the trimmer
head.
2. Make sure that the plant guard can move forward
and rearward freely. (Fig. 35)

Battery information

Refer to the operator's manual of the battery for
information about how to use the battery.
head and cutting attachment guard if they are hit or if
they have cracks.
• Make sure that all nuts and screws are tight.
• Make sure that all covers, guards, handles and the
cutting equipment are correctly attached and not
damaged before you start the product.
To connect the battery charger
1. Connect the battery charger to the voltage and
frequency that is specified on the rating plate.
2. Put the plug in a grounded socket outlet. The LED
on the battery charger flashes green one time.
Note:
The battery does not charge if the battery
temperature is more than 50 °C/122 °F. If the
temperature is more than 50 °C/122 °F, the battery
charger makes the battery become cool before the
battery charges.
782 - 008 - 16.11.2020