Automatic Shutdown Function - Husqvarna 115iL Bedienungsanweisung

To charge the battery
Note:
Charge the battery if it is the first time that you
use it. A new battery is only 30% charged.
1. Connect the battery to the battery charger. (Fig. 36)
2. Make sure that the green charging light on the
battery charger comes on. That means that the
battery is connected correctly to the battery charger.
(Fig. 37)
3. When all LEDs on the battery come on, the battery is
fully charged. (Fig. 38)
4. To disconnect the battery charger from the mains
socket, pull the plug. Do not pull the cable.
5. Disconnect the battery from the battery charger.
Note:
Refer to the battery and battery charger
manuals for more information.
To connect the battery to the product
WARNING:
Husqvarna battery for the product.
1. Fully charge the battery.
2. Push the battery into the battery holder of the
product. The battery locks into position when you
hear a click. (Fig. 39)
CAUTION:
move easily into the battery holder, the
battery is not installed correctly. This can
cause damage to the product.
To start the product
1. Push and hold the start/stop button until the green
LED comes on. (Fig. 40)
2. Push the power trigger lockout and the power
trigger. The cutting equipment starts to rotate.
To adjust the loop handle and
telescopic shaft
1. Loosen the locking handle and adjust the loop
handle to a correct position. (Fig. 41)
2. Close the locking handle.
3. Loosen the lever on the shaft. (Fig. 42)
4. Set the necessary length on the shaft.
5. Close the lever and tighten the screw.
To use the SavE function
This product has a power saving function, SavE.
782 - 008 - 16.11.2020
Only use the initial
If the battery does not
Note:
The SavE function does not decrease the
cutting power of the product.
1. Press the SavE button on the keypad.
2. Make sure that the green LED comes on.
3. Press the SavE button again to disconnect the
function. The green LED goes out. (Fig. 43)

Automatic shutdown function

The product has an automatic shutdown function that
stops the product if it is not used. The green LED for
start/stop indication goes off and the product stops after
45 seconds.
To operate the product
To trim the grass
1. Hold the trimmer head immediately above the
ground at an angle. Do not push the trimmer line into
the grass. (Fig. 44)
2. Decrease the length of the trimmer line by 10-12
cm / 4-4.75 in.
3. Decrease the engine speed to decrease the risk of
damage to plants.
4. Use 80 % throttle when you cut grass near objects.
(Fig. 45)
To clear grass
1. Keep the trimmer head above the ground.
2. Tilt the trimmer head.
3. Cut with the end of the trimmer line around objects in
the work area.
CAUTION:
that are hit by the trimmer line, increases
the wear on the trimmer line.
4. Use 80% speed when you cut and clear vegetation.
This decreases the wear on the trimmer head and
trimmer line.
To cut the grass
1. Make sure that the trimmer line is parallel to the
ground when you cut the grass. (Fig. 46)
2. Do not push the trimmer head to the ground. This
can cause damage to the product.
3. Move the product from side to side when you cut
grass. Use full speed. (Fig. 47)
To sweep the grass
The airflow from the rotating trimmer line can be used to
remove cut grass from an area.
1. Hold the trimmer head and the trimmer line parallel
to the ground and above the ground.
2. Apply full throttle.
Cut grass. Other objects
15