Assembly; Assembling The Sweeper Accessory - Husqvarna BR600 Bedienungsanweisung

D

Assembling the sweeper accessory

1 Press one of the drum axles (A) onto one of the two
outgoing drive shafts from the gear housing (F).
Rotate the drum axle if necessary so that the pin hole
comes over the corresponding hole in the drive shaft.
2 Fasten the roller shaft with locking pin (B).
3 Put one of the brush rollers (C) onto the assembled
shaft. Press in the roller until it stops.

ASSEMBLY

E
F
B
A
C
4 Fasten the roller on the shaft with a cotter pin (D).
Press in the end slightly when assembling.
5 Repeat these steps to assemble the axle and roller on
the opposite side.
6 Mount the splash guard with the snap-on fasteners
(E).
7 For assembling accessories on basic machine, refer
to manual for basic machine.
E
English – 9