Assembly; Operation - Husqvarna 110iL Bedienungsanweisung

• Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
• If you do not do maintenance, it decreases the
life cycle of the product and increases the risk of
accidents.
• Special training is necessary for all servicing and
repair work, especially for the safety devices on the
Introduction
WARNING:
safety chapter before you assemble the
product.
To attach the trimmer guard
1. Put the trimmer guard against the motor housing.
(Fig. 28).
2. Install the bolt through the motor housing and the
trimmer guard. (Fig. 29)
3. Tighten the bolt.
To assemble the trimmer head
1. Turn the output shaft until the hole in the drive disc
aligns with the hole in the gear housing.
2. Install the locking pin in the hole to lock the shaft.
3. Turn the trimmer head clockwise. (Fig. 30)
To assemble the loop handle
1. Attach the loop handle onto the shaft. (Fig. 31)
2. Move the spacer into the slot of the loop handle.
3. Install the screw and the knob. Do not tighten too
much.
4. Adjust the loop handle to an applicable position.
Refer to To adjust the loop handle on page 13 .
5. Tighten the knob.
Introduction
WARNING:
safety chapter before you use the product.
Before you operate the product
• Examine the work area to make sure that you know
the type of terrain. Examine the slope of the ground
and if there are obstacles such as stones, branches
and ditches.
12

Assembly

Read and understand the

Operation

Read and understand the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
• Only use original spare parts.
To assemble the two-piece shaft
1. Align the triangle symbol (A) on the shaft with the
triangle symbol (B) on the shaft coupling. (Fig. 32)
2. Push the shaft into the shaft coupling (C). (Fig. 33)
3. Move the shaft coupling sleeve (D) to the shaft
coupling (C). (Fig. 34)
4. Turn and tighten the shaft coupling sleeve fully. (Fig.
35)
To install the plant guard
1. Install the plant guard into the holes on the motor
housing.
2. Make sure that the plant guard can move forward
and rearward freely. (Fig. 36)
To install the battery charger (40-C80)
on the wall
CAUTION:
Do not use an electric
screwdriver to install the battery charger to
the wall. An electric screwdriver can cause
damage to the battery charger.
1. Install the battery charger on the wall with the 2
screws (B). Use wall plugs (A) if it is necessary. (Fig.
37)
2. Install the 2 screw hole plugs (C).
3. Connect the power cord to the battery charger and a
mains socket.
• Do a general inspection of the product.
• Do the safety inspections, maintenance and
servicing that are given in this manual.
• Examine the motor for dirt or cracks. Use a brush to
clean the motor from grass and leaves. Use gloves
when it is necessary.
• Examine the trimmer head and cutting attachment
guard for damages or cracks. Replace the trimmer
head and cutting attachment guard if they are hit or if
they have cracks.
• Make sure that all nuts and screws are tight.
1728 - 003 - 31.10.2022