Assembly - Husqvarna 520iLX Bedienungsanweisung

follow before you do
maintenance on the
product.
• Remove the battery before
you do maintenance, other
checks or assemble the
product.
• The operator must only do the
maintenance and servicing
shown in this operator's
manual. Turn to your
servicing dealer for
maintenance and servicing of
a larger extension.
• Do not clean the battery or
the battery charger with
water. Strong detergent can
cause damage to the plastic.
Introduction
This section describes how to assemble and adjust the
product.
WARNING:
product, read the safety chapter and the
assembly instructions.
To assemble the loop handle
1. Attach the loop handle onto the shaft between the
arrows.
756 - 007 -

Assembly

Before you assemble the
• If you do not do maintenance,
it decreases the life cycle of
the product and increases the
risk of accidents.
• Special training is necessary
for all servicing and repair
work, especially for the safety
devices on the product. If not
all checks in this operator's
manual are approved after
you have done maintenance,
turn to your servicing dealer.
We guarantee that there are
professional repairs and
servicing available for your
product.
• Only use original spare parts.
2. Move the spacer into the slot of the loop handle.
3. Install the nut, the knob and the screw. Do not
tighten too much.
4. Adjust the product to an applicable position.
5. Tighten the bolt.
To assemble the trimmer guard
1. Install the correct trimmer guard for the trimmer
Accessories on page 25 .
head, refer to
2. Hang the trimmer guard on the hook on the plate
holder (A).
17