Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4 Adjustments
Introduction
4.1
For appropriate measurement of all products and water quantities, several motors and valves are built
in. Modern electronics allow different driving timing to be regulated precisely. Several combinations
are possible that can be implemented, within certain limits, by the service technician. The machine will
be delivered with a standard factory setting. You can always default back to this factory setting. Your
dealer will see to it that your machine will be adjusted to your taste on your location.
Adjustment may only be performed by a qualified service technician.
The settings for quantities of product and water may differ per machine. Every machine has a unique
machine number with a corresponding software version. If you would like to have the setting of your
machine adjusted, this machine number is important for the dealer. The number is located on the
identification plate which, depending on the model, is located inside the machine on the right hand
side wall, top corner.
Products
4.2
This vending machine is solely intended for use with dry instant products. Use of a different product is
not guarenteed to function well. Veromatic International BV is not liable for any damage or quality
degradation if a different product is used. Consult your dealer which products can be used.
Consult the regulations on the product packaging regarding the shelf life and replacement of the
products used.
The machine is set to a specific volume with a predefined mixture and specific timings. This coffee
machine is off factory provided with optimal settings which provide the best in-cup quality. Alternative
products however may require some specific adjustment to guarantee the best result for your drink.
Your dealer can help in making the right choice of products and its settings.
The quantity of product depends on:
•
The duration of time that the product canister motor is on.
•
The spiral auger used in the product canister to dispense the instant powder
•
The amount of water added in the mixer.
Water temperature
4.3
The water temperature of the water inside the boiler can be adjusted by your dealer. In general the
following applies:
•
Temperature too low
•
Temperature too high
The operating water temperature may not be set below 65° C. Below this temperature bacteria will
not be killed and the safety of the user can not be guarenteed.
Product does not dissolve adequately
Water may start to boil under certain circumstances, causing a
safety to turn off the machine. This has to be reset by a service
technician before the machine can be put back into service
39
EN
Werbung
Inhaltsverzeichnis
