Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation location
3.3
The machine is intended only for use indoors, not outdoors. Place the machine in a frost-free location
where it is not exposed to moisture or excessive dust and cannot be sprayed with liquids. The machine
may not be used at an elevation over 2000 m.
The machine is only suited for use in household, office and light-industrial environments. The machine
is not suitable for professional kitchens where cleaning frequently occurs with water or in a dusty
environment. When placed in another environment, Veromatic International cannot guarantee the
correct operation or the safety of the machine.
Do not place the machine in areas that are
cleaned with water jets or steam.
For correct operation the machine may not
be installed at an angle, but at a flat and
stable surface.
The ambient temperature has to be within
+10º to +32º Celsius for a correct
operation of the machine.
Make sure that the wall outlet and the
water valve remain free and easily
accessible after placement of the machine.
The main power switch is located on the
back of the machine. Make sure that this
also remains easily accessible.
Check to see that the electrical cable is not
damaged. A damaged electrical cable must
be replaced immediately!
Make sure there is enough open space
around the machine. Minimum needed
dimensions (in mm) see I 3-1.
Place the machine as such that the highest
surface of the machine is located at least
120 cm above the floor surface.
If the unit is placed directly underneath a cupboard, allow a space of at least 150 mm. For a proper
operation of the machine it is necessary that cooling air can be supplied and discharged. For this
purpose many ventilation openings have been made in the machine. These openings may never be
covered.
Water connection
3.4
Connection data water
Water connection
Water pressure
Water lock
Water filter
The machine must be placed within a distance of 1½ meters from an aerated washing machine tap on
a riser pipe, which relates to the current regulations of the water company and the above-mentioned
operating pressure.
The dispenser must be equipped with a flexible hose set (not supplied) that complies with the current
water and food regulations of the country. The hose must be equipped on the machine side with a
¾''
BSP
2.0 – 8.0
bar
0.2 – 0.8
MPa
Veromatic International BV instructs the use of a water lock and does
not accept any responsibility with regard to water damage, in case the
machine gets installed without this water lock.
Install a water filter to ensure the best taste quality and to reduce scale
and thus maintenance. Replace the water filter regularly. See the water
filter specification for information. Your dealer can inform you about a
water filter and installment.
35
EN
I
3-2
Werbung
Inhaltsverzeichnis
