Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
gland with seal. Whether the machine is new or a replacement, always use a new hose set for the
water supply. Do not reuse the old set for safety reasons.
Connection procedure
1.
Attach the water hose to the tap.
2.
Rinse the water supply thoroughly so possible dirt cannot enter the machine.
When using a water filter, follow the installation guideline of it's manual.
3.
4.
Attach the water hose to the inlet valve on the machine. Tighten the gland well.
5.
Check to see if there are no kinks or damages on the hose.
6.
Open the faucet.
7.
Check for leakage.
Electrical connection
3.5
•
The machine must be connected with the supplied power cord.
•
It is required that a sufficiently fused socket outlet with proven grounding is present within 1½
meters.
•
Use a separate group, for this machine only, with a 16A fuse.
Electrical specifications
Power supply
Frequency
Electrical capacity
Electrical safety class
IP classification
Pollution grade
Overvoltage category
!
ATTENTION:
Allow the machine to acclimate. For that purpose, leave it at least half an hour standing on
the operation location, before plugging it in.
Taste card placement
3.6
The machine is provided with two empty taste cards and a sheet of product stickers. Before
commissioning the correct stickers have to be placed onto the taste cards and installed behind the
glass. The correct sticker placement should correspond to the configuration of the machine. This can
be modified if wished by the service technician.
3.6.1
Standard configuration
The following configuration is pre-programmed as standard.
/3.2
230
V~
50
Hz
2000
W
Class I
IP20
2
II
36
EN
Werbung
Inhaltsverzeichnis
