Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4 Adjustments
!
WARNING:
Only a qualified service technician may make adjustments to the machine!
4.1
Introduction
For appropriate measurement of all products and water quantities, several motors and valves are built in.
Modern electronics allow different driving timing to be regulated precisely. Several combinations are
possible that can be implemented, within certain limits, by the service technician. The machine will be
delivered with a standard factory setting. You can always default back to this factory setting. Your dealer
will see to it that your machine will be adjusted to your taste on your location.
Adjustment may only be performed by a qualified service technician.
The settings for quantities of product and water may differ per machine. Every machine has a unique
machine number with a corresponding software version. If you would like to have the setting of your
machine adjusted, this machine number is important for the dealer. The number is located on the
identification plate which, depending on the model, is located inside the machine on the right hand side
wall, top corner.
4.2
Products
This vending machine is solely intended for use with coffee beans and dry instant products. Use of a
different product is not guarenteed to function well. Veromatic International BV is not liable for any
damage or quality degradation if a different product is used. Consult your dealer which products can be
used. Consult the regulations on the product packaging regarding the shelf life and replacement of the
products used.
The machine is set to a specific volume with a predefined mixture and specific timings. This coffee
machine is off factory provided with optimal settings which provide the best in-cup quality. Alternative
products however may require some specific adjustment to guarantee the best result for your drink. Your
dealer can help in making the right choice of products and its settings.
The quality of product depends on many factors, for example:
•
The amount of coffee in the brewer.
•
The amount and pressure of water running through the brewer.
•
The grind size
•
The duration of time that the product canister motor is on.
•
The spiral auger used in the product canister to dispense the instant powder
•
The amount of water added in the mixer.
4.3
Water temperature
The water temperature of the water inside the boiler can be adjusted by your dealer. In general the
following applies:
•
Temperature too low
•
Temperature too high
The operating water temperature may not be set below 65° C. Below this temperature bacteria will not be
killed and the safety of the user can not be guarenteed.
Product does not dissolve adequately or wrong extraction
Water may start to boil under certain circumstances, causing a safety
to turn off the machine. This has to be reset by a service technician
before the machine can be put back into service
48
EN
Werbung
Inhaltsverzeichnis
