Connecting To A Computer - Epson EasyMP EMP-735 Aufstellungsanleitung

Connecting Using Easy Connect Mode

Connecting to a Computer

When finished applying the settings, run EMP NS Connection on the computer, and
establish a connection with the projector. Once these settings have been established,
future sessions can begin by just connecting the devices.
Tip :
• Install the wireless LAN card in the computer before starting EMP NS Connection. The
wireless LAN card will not be recognised by the EMP NS Connection if the wireless
LAN card is installed after EMP NS Connection is started.
• Set the WEP
functionality.
1
In Windows, select "Start" - "Programs" (or "All Programs") - "EMP NS
Connection" - "EMP NS Connection".
EMP NS Connection starts.
2
The following Switch network screen is displayed upon initial start-up
after installing EMP NS Connection. Proceed with Step 4 if the Switch
network screen is not displayed.
Tip :
In the event that the IP address has not been set in the projector's network settings, the
message, "There is no network adapter" may be displayed. This is because it takes time
to determine the IP address, if the projector cannot connect to the DHCP
Please wait about 30 seconds and then repeat the process from Step 1.
30
to OFF in either the wireless LAN card or for internal wireless LAN
server.