Epson EasyMP EMP-735 Aufstellungsanleitung Seite 49

Connecting in Access Point Mode
Tip :
The projector keyword changes each time the projector power is turned OFF and ON
again, and when the wireless LAN card is removed and reinstalled. When connecting to
a computer, make sure the projector keyword displayed in the Connection Stand-by
screen is entered. Connection is not possible using a previous keyword.
Connection Settings on the Computer
In this section we will address the computer connection setup. Connection setup is
performed using the utility software provided with the wireless LAN card.
If these settings are already established, this step need not be performed.
1
Turn on the computer and start Windows.
2
Start up the wireless LAN card utility software.
Refer to the documentation for the wireless LAN card for instructions on how
to use the wireless LAN card utility software.
Establish settings enabling the computer to function on the network.
Connecting to a Computer
When finished applying the settings, run EMP NS Connection on the computer, and
establish a connection with the projector. Once these settings have been established,
future sessions can begin by just connecting the devices.
Tip :
Install the wireless LAN card in the computer before starting EMP NS Connection. The
wireless LAN card will not be recognised by the EMP NS Connection if the wireless LAN
card is installed after EMP NS Connection is started.
48
The value is displayed here.