Epson EasyMP EMP-735 Aufstellungsanleitung Seite 28

Channel
Enter under "Ad hoc mode settings" when "Channel ad
hoc"is selected.
Enter the channel used for channel ad hoc mode. The initial
value is " 11."
From 1-14 channel numbers can be selected.
Be sure to enter the same channel number(s) on the
connected computer.
* Some channel numbers may be unavailable in some
countries. Channel numbers that are unavailable in the
country of purchase have been pre-configured so they do
not display.
Password for Enter a password. If you enter a password, entry of that
WEB control password will be required when; opening the settings and
control browser page to change the projector settings via
network from a computer's web browser, and when starting
EMP Monitor.
Up to 8 single-byte alphanumeric characters are available.
Select the "Clear" button, and press the [Enter] button on
the remote control to clear the entered password. The
password setting will be inactivated.
Projector
If the projector keyword option is set to "ON", keyword
keyword
entry will be required when using EMP NS Connection to
connect to the projector over a wireless LAN. A keyword
will be displayed on the screen of the projector you are
trying to connect to. Please check this keyword and enter it
into the computer you are trying to establish the connection
from. If the keyword is entered correctly, connection is
established and the projector will project the images shown
on the computer display. Use this function to prevent
unintended or unauthorized access to the projector during
presentations, from other points on the wireless LAN.
This option should normally be "ON". To disable this
option, select "OFF".
MAC Displays the wireless LAN card MAC address.
address
*
27