Epson EasyMP EMP-735 Aufstellungsanleitung Seite 29

Connecting Using Easy Connect Mode
Entering Letters and Numbers
Perform the following steps to enter letters and numbers.
1. Move the cursor to the item to input, and press the [Enter] button on the remote
control. The cursor turns green to indicate you are in input mode.
2. Select numbers or letters by pressing the [ ] button or the [ ] button. Press and
hold the [ ] button or the [ ] button to perform rapid key repeat, this makes the
rapid selection of desired letters and numbers possible. For the projector name,
ESSID, and WEB control password, characters are presented in this order by
pressing the [ ] button : A-Z → 0-9 → symbols → a-z → space. Press the [ ]
button to reverse the display order.
3. To input two or more numbers or letters, press the [ ] button on the remote
control. The first number or letter is selected and the cursor moves to the second
entry position. Select the second, and all the subsequent numbers and letters in
the same way as the first character.
4. After you have entered all the characters, press the [Enter] button on the remote
control to finalise the entry. The cursor will turn yellow.
8 When finished making setting changes, press the [Page up] button on
the remote control, and move the cursor to "OK". Press the [Enter]
button.
This applies the setting changes and returns to the Network advanced settings
screen.
If you wish to cancel the change and return to the state before changes were
made, move the cursor to "Cancel" and press the [Enter] button.
9 Press the [Page up] button on the remote control to move the cursor to
"OK", and press the [Enter] button.
This returns to the Connection Stand-by screen. The ESSID or channel number
that was set is displayed. If "Projector keyword" is "ON", the keyword is also
displayed.
When "Cancel" is selected, all changes made in each mode, (including
advanced settings) are canceled, and the projector returns to its previous
conditions, before changes were made.
28