Connecting In Access Point Mode; Before Connecting - Epson EasyMP EMP-735 Aufstellungsanleitung

Connecting in Access Point Mode

In addition to the Easy Connect mode, there is also the Access point mode for
connecting a computer to a projector via a network.
Access point mode is a mode for connecting a projector to a computer through a
wireless LAN access point on an existing network system. When using a computer
connected through an access point, under normal circumstances, the computer's
wireless LAN settings remain unaltered, and only the projector is set up.
In addition to being able to project computer images using the projector, you can
use EMP Monitor and SNMP
from a computer.
"Management Using SNMP" in the EasyMP Operation Guide.

Before Connecting

Ensure the following have been performed before connecting a computer and
projector to a network.
• Install EMP NS Connection on the computer you will be using.
• Prepare the computer settings to use either a wireless LAN card or
internal wireless LAN functionality. For setup, see the documentation for
the wireless LAN card installed in the computer, or the computer's
documentation.
• The size of the projected image varies depending on the distance of the
projector from the screen. Decide on the projector placement so that the
image matches the screen size.
Distance" in the EMP-735 User's Guide.
• For optimal performance, set the screen resolution of the computer you
are using to XGA or lower with a colour depth of 16bit.

Connecting in Access Point Mode

Caution :
• Do not unplug the power cable when EasyMP is in use (screens are changing or the
access lamp on the wireless LAN card is lit green).
• Do not remove the wireless LAN card when the access lamp on the wireless LAN card
is lit green, or when connected to a network. Doing so may damage the wireless LAN
card.
to monitor and control the status of the projector
See"Monitoring and Control Using EMP Monitor" and
See "Screen Size and Projection
p.19
41