N Ose; T Ools - SUHNER ABRASIVE LTB 6 - 930 Originalbetriebsanleitung

3. handling / Operation
3.1 n
ose
observed! Only use noses which are in perfect condition.
Check nose before use. The nose must be centred and
secured with the lock nut.
V
ery shArP BlAde
3.1.1 c /c
hAnging onnecting the nose
Screw nose to pneumatic drive, align it, and secure it with
the lock nut. After connecting, press the grease can but-
ton two to three times. If you cannot completely screw in
the nose, turn the ring cutter slightly.
V
ery shArP BlAde
3.2 t
ools
Use only clean tools!
3.2.1 c /
onnecting detAching the BlAde
Use an allen key to loosen the four allen screws.
Only use SUHNER noses.
The instructions issued by
the manufacturer must be
!
!
Remove the blade housing by drawing it towards you.
Detach the blade from the blade housing. To connect
the blade, follow the above instructions in reverse order.
Tighten the screws with max. 1.5 Nm. After connecting,
press the grease cup button two to three times.
V
ery shArP BlAde
3.2.2 c /
onnecting detAching the dePth gAuge
Position the depth gauge in the blade housing. Secure/
release the depth gauge at the two allen screws.
!
29