Electric Starter; Manual Starter; Interruption Of Operation; Decommissioning - Eisemann T 4411 Originalbetriebsanleitung

• Turn on the circuit breakers.
• Set the ignition key to the position "I".
• To start a cold engine, move the choke rod to the "CLOSED" position.
5.6.1.

Electric starter

If the engine fails to start within 5 seconds, release the key, and wait at least 10 seconds
Using the electric starter for more than 5 seconds at a time will overheat the starter motor and
• Turn the ignition key to the " " Position and hold it until the engine runs.
• If the choke rod has been moved to the CLOSED position to start the engine, gradually move it
to the OPEN position as the engine warms up.
• The consumers can now be turned on.
5.6.2.

Manual starter

• Pull the starter grip lightly until you feel resistance, then pull rapidly. Repeat until the engine
runs.
Do not allow the starter grip to snap back against the engine.
• If the choke rod has been moved to the CLOSED position to start the engine, gradually move it
to the OPEN position as the engine warms up.
• Close the engine hood.
• The consumers can now be turned on..
5.6.3.

Interruption of operation

• Turn the ignition switch to the "0" position. The engine shuts off.
5.6.4.

Decommissioning

• Turn the ignition switch to the "0" position. The engine shuts off.
• Turn off the circuit breakers.
• Pull the consumer plugs out of the electrical sockets.
Seite 30
NOTICE
before operating the starter again.
can damage it.
NOTICE
Return it gently to prevent damage to the starter.