Before Use; Initial Use; Switching The Product On / Off; Installing The Product - Parkside PAS 10 A1 Bedienungs- Und Sicherheitshinweise

Avoid the risk of fatal injury
from electric shock
Check the product for damages before con-
necting it to the power supply. Never use the
product if it is damaged in any way.
Protect the mains cable from sharp edges,
mechanical strain and hot surfaces.
Only touch the insulated part of the mains plug
when connecting or disconnecting it from the
mains supply!
Always unplug the mains plug from the socket
before mounting, removing or cleaning it.
Disconnect the product from the mains power if
you are not using it for long periods (e.g. when
on holiday).
Never open any of the electrical equipment or
insert any objects into this equipment. Such
interferences pose a risk of fatal injury from
electric shock.
Before use, ensure that the available mains
voltage matches the operating voltage required
by the product (220–240 V∼, 50 Hz).
Prevent fire and
injury hazards
CAUTION! RISK OF BURNS DUE TO HOT
SURFACES! To prevent burns, make sure that
the product has been switched off and has
cooled down before touching it. Illuminants
become very hot.
Do not cover the product with any objects. Ex-
cessive heat can result in fire.
Never leave the product unattended whilst in
operation. Excessive heat can result in fire.
The LED module is not dimmable.
Do not look directly into the light source (illumi-
nant, LED etc.). Do not look into the light source
(illuminant, LED, etc.) with an optical instrument
(e.g. magnifying glass).
A shattered protective covering must
always be replaced.
14 GB/IE
Never aim the LED light beam at reflective sur-
faces or at people or animals. Failure to observe
this instruction can lead to eye injuries and / or
loss of sight in people or animals. Even a weak
LED light beam can cause eye damage.
Disconnect the product from the mains supply
whenever you want to set it up in a different
location.
The product is not suitable for use as room
lighting.

Before use

Note: Remove all packaging materials from the
product.
Note: Protect delicate surfaces before setting up
the product.
Loosen the knurled screw
of the product by turning it anticlockwise, in or-
der to move the fold-out stand
position.
Then re-tighten the knurled screw
turning it clockwise.
Set up the product in the desired location.
Note: The lamp head can be continuously
tilted.

Initial use

Switching the product on / off

To switch the product on, plug the mains plug
into a properly installed mains socket.
4
Note: Insert the mains plug
plug socket to guarantee the protection against
splashing water.
To switch the product off, remove the mains
plug from the mains socket.
4

Installing the product

You can mount the product on a tripod or a wall,
or hang it up using the fold-out hook
/ on the side
3a 3b
to the desired
5
/ by
3a 3b
into an IPX4
4
.
6