Operation And Use; Charging The Power Bank; Checking The Battery Status - Silvercrest SQWP8000 1A1 Bedienungs- Und Sicherheitshinweise

If charging does not start even after the supported device has
been placed in the charging area, place the device near the
[Qi] mark in the center of the charging area.
Before starting with wireless charging, read the instructions
provided with the mobile device as well.
If you use a USB power supply, the socket used must always be
easily accessible so that the USB power supply can be quickly
removed from the socket in the case of emergency. Please also
refer to the manufacturer's instruction manual.
ATTENTION Two Qi charging devices and/or power banks
must never be placed on top of each other with the charging
surface. A device defect is the possible consequence.
P Operation and use

Charging the power bank

The built-in rechargeable battery must be fully charged before using
the product.
To charge the power bank
output voltage of 5 V and an output current of at least 3 A.
ATTENTION The power bank must not be charged from a
PC or notebook.
Connect the USB cable
the power bank
Connect the other end of the USB cable
USB power supply (not included in the scope of delivery) (see
fig. A).
ATTENTION Do not connect any device to the Powerbank for
charging while the Powerbank itself is charging.

Checking the battery status

You can check the battery status on the battery status indicator
of the power bank
GB/IE 32
8 only use power supplies with an
with the Micro-USB input port
9
.
8
at anytime.
8
9 (USB Type A) to a
of
1
6