Before Use; Operation And Use; Charging The Power Bank - Silvercrest SPBL 10000 C3 Bedienungs- Und Sicherheitshinweise

The product should never be charged at a PC or notebook,
because due to the high power consumption, the PC or
notebook could be damaged.
P Before use
NOTE: Remove all packaging materials from the product.
Please also check the content of delivery inside the
packaging to see if there are any damages. If you notice
any damage or missing parts, please contact the dealer
who sold this product.
P Operation and use

Charging the power bank

The built-in rechargeable battery must be fully charged before
using the product.
To charge the power bank
an output voltage of 5 V and an output current of at least
3 A.
ATTENTION! The power bank should not be charged
from a PC or notebook.
Connect the USB Type A to USB Type C cable
USB Type C input port
Connect the other end of the USB Type A to USB Type
C cable
7
included in the scope of delivery) (see fig. A).
The display
the internal battery in percent. After approx. 10 seconds
the display goes out, you can display the value again by
pressing the ON / OFF button
GB/IE 28
1
(USB Type A) to a USB power supply (not
shows you the approximate charge level of
4
only use power supplies with
6
of the power bank
.
5
with the
7
.
6