Controlling External Devices With The Remote Control; Registering The Remote Control Code For A Tv - Yamaha R-N500 Bedienungsanleitung

Controlling external devices with the remote control

Controlling external devices with the remote control
You can use the unit's remote control to operate external devices (such as CD players) if you have registered the remote
control code of the external device.
Notes
• You cannot control an external device that does not have a remote control sensor.
• Ensure that the remote control ID of the external device is set to "ID1". If any other ID is selected, the remote control operations may
not work properly.
• If the unit's remote control is without batteries for more than 2 minutes, the registered codes may be cleared. If this happens, insert
new batteries and register the codes again.
Registering the remote control
code for a TV
You can use the unit's remote control to operate a TV if
you have registered its remote control code.
y
You can also register your TV's remote control code to the unit's
input selection keys (p.37). This would allow you to use the
cursor keys or numeric keys to operate the TV (this function may
not be available on some TV models).
SOURCE
ID
COAX1
1
5
9
TV INPUT
TV MUTE
1
Refer to "LIST OF REMOTE CONTROL
CODES" (end of this manual) to find your
TV's remote control code.
y
If there are multiple remote control codes, register the first code
in the list. If that does not work, try the other codes.
2
Press CODE SET using a pointed object such
as the tip of a ballpoint pen.
Perform each of the following steps within 1 minute.
Otherwise, the setting will be canceled. If this
happens, repeat from Step 2.
3
Press TV A.
36
En
CODE SET
CODE SET
RECEIVER
SLEEP
SPEAKERS
DIMMER A B
COAX2 OPT1 OPT2
2 3 4
Numeric keys
6 7 8
+
0 10 ENT
TV
TV operation keys
TV VOL TV CH
TV A
4
Use the numeric keys to enter the 4-digit
remote control code.
Once the remote control code is successfully
registered, "Rem: Success" appears on the front
display.
If "Rem: Fail" appears on the front display,
registration has failed. Repeat from Step 2.
■ TV operations
Once you have registered the remote control code for your
TV, you can control it using the TV operation keys,
regardless of the input source selected on the unit.
Switches the video inputs of the TV.
INPUT
Mutes the audio output of the TV.
MUTE
TV
Adjust the volume of the TV.
operation TV VOL
keys
Switch the channels of the TV
TV CH
Turns on/off the TV.
TV A