Connecting The Speakers; Setting The Speaker Impedance; Connecting Speaker Cables; Bi-Wire Connection - Yamaha R-N500 Bedienungsanleitung

Connecting the speakers

■ Setting the speaker impedance

Under its default settings, the unit is configured for 8-ohm
speakers. When connecting 4 to 6-ohm speakers, set the
speaker impedance to "4  MIN".
1
Before connecting speakers, connect the
power cable to an AC wall outlet.
2
While holding down RETURN on the front
panel, press A (power).
A
(power)
3
Check that "SP IMP." is displayed on the
front display.
SP IMP.
4 Press SELECT/ENTER to select "4  MIN".
5
Press A (power) to set the unit to turn off and
remove the power cable from the AC wall outlet.
You are now ready to connect the speakers.

■ Connecting speaker cables

Speaker cables have two wires. One is for connecting the
negative (-) terminal of the unit and the speaker, and the
other is for the positive (+) terminal. If the wires are
colored to prevent confusion, connect the black wire to the
negative and the other wire to the positive terminal.
a Remove approximately 10 mm (3/8") of insulation from the ends of
the speaker cable and twist the bare wires of the cable firmly together.
b Loosen the speaker terminal.
c Insert the bare wires of the cable into the gap on the side (upper
right or bottom left) of the terminal.
d Tighten the terminal.
10 mm
a a
(3/8")
c c
b b
d d
RETURN
SELECT/ENTER
8 MIN

■ Bi-wire connection

Bi-wire connection separates the woofer from the
combined midrange and tweeter section. A bi-wire
compatible speaker has four binding post terminals. These
two sets of terminals allow the speaker to be split into two
independent sections. With these connections, the mid and
high frequency drivers are connected to one set of terminals
and the low frequency driver to another set of terminals.
This unit
Connect the other speaker to the other set of terminals in
the same way.
Note
When making bi-wire connections, remove the shorting bridges
or cables on the speaker.
y
To use the bi-wire connections, press SPEAKERS A and
SPEAKERS B on the front panel or on the remote control so that
both SP A and B light up on the front display.
SPEAKERS A/B
SOURCE
ID DIMMER
COAX1 COAX2
Connections
Speaker
CODE SET
RECEIVER
SLEEP
SPEAKERS
A B
SPEAKERS A/B
OPT1 OPT2
11
En