Operation; Operation General - probst QUICKJET QJ-600-E Betriebsanleitung

Operating Instructions
QJ 600-E
Pos : 23 /06 Bedi enung/06 Bedi enung u. Ei nstellungen/KÜ_Bedi enung @ 0\mod376_2.doc x @ 5705 @ 1 @ 1

6 Operation

Pos : 24 /99 g erätes pez. M odul e/PG2 Vakuum-Verleges ysteme/52400033 QJ 600 e/Bedienung_QJ 600 e @ 3\mod_1258559486422_2.doc x @ 29569 @ 23 @ 1
6.1

Operation general

The main power supply must be fixed at the hand grip with the provided power cable holder (1). Against
accidental release (e.g. by accidentally stepping on the cable with the following: Last falls down) (see
15.)
If you set down the unit with the motor running, take care not to place it on an airtight surface, since this
will block the flow of cooling air. Instead, place the unit on a support (such as a block of wood).
Always switch off the unit if you do not intend to use it again within two minutes.
14. Position the power cable (3), coming from the
blower unit
16. To adjust the hand grip () to the desired
working height,
19 / 25
at the hand grip ().
Operation
15. Remove the mains power cable from power
cable holder (1) and also the cable socket
(2) from the cable connector (3).
17. pull both spring bolts a little out (right and left of
the device) then turn and release it.
GB