Installation Honda Generator Eu 20 I - probst QUICKJET QJ-600-E Betriebsanleitung

Operating Instructions
QJ 600-E
Pos : 20 /99 g erätes pez. M odul e/PG2 Vakuum-Verleges ysteme/52400033 QJ 600 e/Installation_H onda-Stromerzeuger_QJ 600 e_52400033 @ 3\mod_1258537804904_2.doc x @ 29533 @ @ 1
5.2

Installation HONDA generator EU 20 i

When installing the Honda generator to the designated place on the device "QJ 600 e", the vacuum blower
must be switched off. The device must be stand completely on the floor (on even ground).
1. Remove the power cable from power cable
holder (1) and pull off the cable socket (2) from
the cable plug (3).
3. Then attached the electric socket at the terminal
clamp (in front of the blower unit).
4. Pull both spring bolts a little out (right and left of
the device) then turn and release it.
16 / 25
Installation
2. Remove power cable ((3) coming from blower
unit) from the holder at the handgrip.
5. Move the handgrip downwards (),so that the
HONDA generator can be installed on the
device.
GB