Finishing Work - ATIKA ASP 10-1350 Bedienungsanleitung Sicherheitshinweise Ersatzteile

Adjusting the table height
Upper table plate position for logs up to 59 cm
Middle table plate position for logs up to 85 cm
Lower table plate position for logs up to 135 cm
1. Split logs
up to 59
cm on the
table plate
(6).
2. Split logs
up to 89
cm on the
table (7).
Pull out
the table
plate (A).
3. Split logs
up to135
cm on the
base (10).
Press the
locking
lever (8)
down and
swing
aside the
table (7).
Adjusting the splitting cross:
1. Loosen fixing screw.
2. Move the splitting cross to the required position.
3. Mount fixing screw.
Fixing screw
13
Splitting
cross
Splitting short wood:
1. Upper position of table plate.
2.
Place the log on the splitter's table plate.
Only split the logs in the direction of the wood fibres.
3. Hold the log tight with the clamping claws.
Downloaded from www.Manualslib.com manuals search engine
Splitting long wood:
1. Middle or
position of table
or base.
2. Remove
splitting cross.
12
3. Place the log on
the splitter's table
or base.
Possible malfunction when cleaving logs: The log to
be cleaved is not cleaved right through, jams on the cleaving
blade and is pulled up during the blade's return movement. It
is no longer possible to release the log manually.
In this case, proceed as follows:
1. Switch off the device.
2. Depending on the log still to be cleaved fix the table plate
(6) in the upper position or swing aside the table (7).
3. Switch on the device and continue the splitting operation.
Never try to split two logs at once.
Never try to remove or replace the log during the splitting
process.
Never try to force the splitting of the log by maintaining
the pressure for several seconds. This can lead to damage
to the machine.
Position the log on the table again and repeat the splitting
phase, or put the log on one side.
How to release a jammed log?
There is a risk of knotted logs getting stuck during the
splitting process.
1. Switch machine off and disconnect the power.
2. Carefully move the stuck log backwards and forwards to
loosen it.
Never hammer on the stuck log.
Never use a saw to cut the stuck log out of the
machine.
Do not enlist the aid of a second person - this is a one-
man job.

Finishing work:

Bring the splitting blade to the lower position (run-in
state).
Release one of the control handles.
Switch the machine off and disconnect the power.
Follow the care and maintenance instructions.
21
low
14
the
15