Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
C
a
r
e
a
n
d
C
a
r
e
a
n
d
Remove the plug from the power socket before
starting any maintenance or cleaning work.
Wear protective gloves in order to avoid injury to the
hands.
Observe the following in order to keep the log splitter in
good working order:
Clean the machine thoroughly after you have
finished using it.
Remove any resin remains on the machine.
Lubricate the splitting column regularly or oil it using
environmentally friendly spray oil.
Check the oil level and change the oil as necessary.
Check hydraulic hoses and hose connections
regularly for any leaks and firm fitting.
Sharpening the splitting blade
After longer operating periods, for reduced splitting
performance or slight deformation of the cutting edge, grind
the splitting blade or sharpen it with a fine file (remove burrs).
15
How do I check the oil level?
1. The splitting column
must be in run-in
state.
2. Now remove the
dipstick.
3. Clean the dipstick
and the oil seal.
4. Replace the dipstick
fully into the oil
reservoir.
5. Now remove the
dipstick again, and
read off the oil level.
Downloaded from
www.Manualslib.com
m
a
i
n
t
e
n
a
n
c
e
m
a
i
n
t
e
n
a
n
c
e
Sharpen
wedges
manuals search engine
If the oil
level
is
between
the
two
marking
on
the
dipstick, there
is sufficient oil
in
the
reservoir.
If the oil
level is below
the
lower
marking, more
oil should be
added with the
aid of a clean funnel.
6. Check the
oil seal and
replace it if
it is dama-
ged in any
way.
7. Replace the dipstick into the oil reservoir.
When should I change the oil?
The first oil change should be carried out after 50
operating hours, and then every 500 operating hours.
Two persons are required for this.
Changing the oil:
1. The splitting column must be in run-in state.
2. Now remove the dipstick.
3. Place a container under the log splitter to catch the old
oil. The container should have a capacity of at least
7 litres.
16
4.
Screw
off
the
drain
plug
to
allow the oil
to flow out.
5.
Insert
the
seal
and
drain plug
again.
6.
Pour in the
new
hydraulic
oil
(7.0
litres) using a clean funnel.
7.
Clean the dipstick and the oil seal.
8.
Check the oil seal and replace it if it is damaged in any
way.
9.
Replace the dipstick.
22
17
Oil dip stick
upper marking
lower marking
18
19
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
