Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Unscrew venting cap (9) by several turns so that air
may escape from the oil tank.
Leave the cap open during operation.
Close the venting cap before moving the log splitter,
a otherwise oil will leak at this point.
s
If the hydraulic system is not vented, the trapped air will
damage the seals and cause permanent damage to the
log splitter.
Mains connection
Compare the voltage given on the machine model plate
e.g. 230 V with the mains voltage and connect the
machine to the relevant and properly earthed plug.
Only use connection cables with sufficient cross-
sections.
Connect the machine via a 30 mA fault current safety
switch.
Fuse protection
400 V 3~
Switching on / off
Prior to every use, check the function of the
disconnection mechanism (by switching on and off).
Do not use any device where the switch can not be
switched on and off. Damaged switches must be
repaired or replaced immediately by the customer
service.
Switching on
Press the green button.
Switching off
Press the red button.
Lock in case of power (zero-voltage
initiator)
The equipment will switch off automatically if there is a power
cut. Repress the green button to switch it on again.
Log splitter with 400 V 3~
Make sure that the motor turns in the correct direction
(see motor arrow), because operation in the wrong
direction damages the oil pump.
Switch on motor; the splitting blade automatically moves
to the highest position.
If the splitting blade is already in its highest position: grip
both operating handles and push them down. The
splitting blade moves downwards.
Downloaded from
www.Manualslib.com
16 A
6
manuals search engine
If the splitting blade does not move after the motor has
started, switch off the motor and change the direction of
rotation.
7
Hydraulics
Never operate the machine in the event of any possible
danger from hydraulic fluid.
Ensure that the machine and working area are clean and
free of oil.
Danger of slippage or fire!
Check the hydraulic reservoir regularly to ensure that it
contains enough hydraulic oil (see "Care and
maintenance")
Capacity: 7.0 litres
W
o
r
k
i
n
g
w
i
t
h
t
h
W
o
r
k
i
n
g
w
i
t
h
t
h
SAFETY INSTRUCTIONS
Additional
The log splitter may only be operated by a single person.
The machine may only be operated by persons over the
age of 18 years, and who have read and understood
these operating instructions.
Wear protective equipment (safety goggles/mask, gloves,
safety shoes) to protect yourself from possible injury.
Never try to split logs containing nails, wire or other
similar objects.
Already split wood and wood chips create a dangerous
working area. The operator may stumble, slip or fall.
Always keep the working area neat and tidy.
Never place the hands on or near any moving parts of the
machine when it is switched on. Maintain a safe distance
from the log, the ram and the wedge in order to protect
your hands from injury.
The machine should only be used for splitting logs with a
maximum length of 1350 mm.
Check before splitting if the splitting column has
been sufficiently lubricated to allow its trouble-free
retraction and extension.
19
You can change
the
direction
placing
screwdriver in the
slot provided in the
plug
collar,
adjust the correct
direction by moving
to the left or right
applying
slight
pressure.
e
l
o
g
s
p
l
i
t
t
e
r
e
l
o
g
s
p
l
i
t
t
e
r
by
a
and
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
