Herunterladen Inhalt Inhalt Diese Seite drucken

CAME E306 Bedienungsanleitung Seite 8

Inhaltsverzeichnis

Werbung

APPLICAZIONE
ALBERI QUADRI
E781A
- Inserire gli alberi quadri al motore lasciandoli spor-
gere di 35 mm e bloccarli con i grani di fissaggio posti
sull'albero motore (fig. 6). Lubrificare le boccole e in-
serirle nei rinvii. Tagliare il tubo di trasmissione 10 mm
più corto delle distanze L1 ed L2 (distanza tra il profilo
della boccola e il profilo dell'albero motore). Lubrificare
e inserire il braccio nel tubo e collegare quest'ultimo
alla boccola e al rinvio come da fig. 7.
Tubo
Tubo
Tube
Tube
Rohn
Rohr
Boccola
Bushing
Boccola
Douille
Bushing
Buchse
Casquillo
Casquillo
Braccio
Arm
Braccio
Bras
Arm
Brazo
Brazo
APPLICATION SQUARE SHAFTS E781A
- Fit the square transmission shafts to the motor so
that they protrude by 35 mm. Anchor the transmission
shafts by tightening the screws on the motor drive
shaft (see fig. 6).
Lubricate the bushings and insert them into the trans-
mission system. Cut the tube so that it is 10 mm shorter
than the distances L 1 and L2 (i.e. the distance between
the face of the bushing and the edge of the motor
drive shaft). Lubricate the arm and insert into the tube.
Connect the tube to the bushing and the transmission
system as shown in fig. 7.
L1 - 10 mm
- Introduzca los árboles cuadrados en el motor dejando
que sobresalgan 35 mm y bloquéelos con los tornillos
de fijación colocados en el árbol motor (fig.6).
Lubrique los casquillos y móntelos en las transmisiones.
Acorte el tubo de transmisión 10 mm menos que las
distancias L1 y L2 (distancia entre el perfil del casquillo
y el perfil del eje motor).
Lubrique e introduzca el brazo en el tubo y una éste
último al casquillo y a la transmisión, tal corno indica
la fig. 7.
Albero quadro
Panel shaft
Albero quadro
Arbre à section carrée
Panel shaft
Eje cuadrado
Vierkantwellen
Eje cuadrado
L2 - 10 mm
INSTALACIÓNÁRBOL CUADRADOSE781A
Fig. 6
Vite
Albero quadro
Screw
Panel shaft
Tornillo
Eje cuadrado
Albero motore
Motor shaft
Eje motor
Fig. 7
Rinvio
Transmission system
Reenvio
Boccola
Bushing
Casquillo
Tubo
Tube
Rohn
Braccio
Arm
Brazo

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

E456E1024

Inhaltsverzeichnis