Filling Of The Water Softener Container - Pkm DW12A++7TI Bedienungsanleitung

You can set the consumption of water softener from H0 to H7. Salt is not required
when the value H0 is set.
1. You need to get the information on the local water hardness range. You can
receive all relevant information from your local water supplier.
2. You find the values for proper setting on the schedule below.
3. Close the door.
4. Press the ON/OFF button.
5. Hold the Delay button and press the Programme button for 5 seconds. You will
hear an acoustical signal once. H flashes on the display. The factory setting is
H4.
Changing of the setting:
1. Press the Delay button. Each pressing increases the value by 1. When H7 has
been reached, the setting will jump back to H0 (off).
2. Press the Programme button to save your setting.
Water hardness range *
0
dH
0-6.4
6.4-8.6
8.7-9.6
9.7-12.0
12.0-16.0
16.1-21.0
21.1-30.3
30.4-49.5
* You can find water hardness calculators on the internet.
B. Filling of the water softener container
The water softener container is beneath the lower dish rack.
Only use a water softener (= dishwasher salt) which is suitable for
dishwashers. Other water softeners and salts, especially table salt, will damage
the water softener container.
1. Unscrew the cap of the water softener container.
2. There is a ring with an arrow on it on the
container. Rotate the ring towards + for refilling.
Range
soft
soft
medium
medium
medium
hard
hard
hard
55
Mmol/l Required setting
0-1.1
1.2-1.4
1.5-1.8
1.9-2.1
2.2-2.9
3.0-3.7
3.8-5.4
5.5-8.9
H0
H1
H2
H3
H4
H5
H6
H7