EINHELL TC-TS 2225 U Originalbetriebsanleitung Seite 82

The offcut piece remains on the saw table (1) until the blade (4)
•
is back in its position of rest.
Secure long workpieces against falling off at the end of the cut
•
(e.g. with a roller stand etc.).
8.1.1 Cutting narrow workpieces (Fig. 22)
Be sure to use a push stick (3) when making
longitudinal cuts in workpieces smaller than 150
mm in width. A push block is supplied with the saw! Replace a worn
or damaged push stick immediately.
8.1.2 Cutting extremely narrow workpieces (Fig. 23)
Be sure to use a push block when making
•
very narrow workpieces with a width of 50 mm and less.
The low guide face of the parallel stop is best used in this case.
•
There is no push block supplied with the saw! (Available from
•
your specialist dealer). Replace the push block without delay
when it becomes worn.
8.2 Making bevel cuts (Fig. 24)
Bevel cuts must always be used using the parallel stop (7).
If you tilt the saw blade (4) to the left when making angular cuts,
position the parallel stop (7) on the right-hand side of the saw blade
(4). Guide the workpiece between the saw blade (4) and the parallel
stop (7).
Set the blade (4) to the desired angle. (See 7.5.)
•
Set the parallel stop (7) in accordance with the workpiece width
•
and height (see 7.3)
Carry out the cut in accordance with the workpiece width (see
•
8.1.1., 8.1.2.)
8.3 Making cross cuts (Fig. 25)
Slide the cross stop (21) into one of the grooves (21) in the table
•
and adjust to the required angle. (See 7.4.) If you also want to tilt
the blade (4), use the groove (21) which prevents your hand and
Anl_TC_TS_2225_U_SPK7_Rewe.indb 82
GB
longitudinal cuts in
- 82 -
24.03.2020 10:29:27