EINHELL TC-TS 2225 U Originalbetriebsanleitung Seite 57

5. Service
a) Have your power tool repaired only by trained personnel
using only genuine spare parts. This will ensure that your po-
wer tool remains safe to use.
Special safety information for bench-type circular saws
1) Safety information relating to the safety guards
a) Leave the safety guards fi tted in place. Safety guards must
always be in proper working order and fi tted correctly. Loo-
se, damaged or defective safety guards must be repaired or re-
placed.
b) Always use the saw blade safety guard and the splitter
when performing separation cuts. For separation cuts in
which the saw blade cuts right through the workpieces thickness,
the safety guard and other safety equipment reduce the risk of
injuries.
c) Do not use this saw to cut rebates or grooves. For design
reasons, the saw is not suitable for such work. The splitter must
never be removed, because it prevents jamming and kickbacks.
d) Before switching on the power tool, make sure that the saw
blade does not touch the safety guard, splitter or workpie-
ce. Accidental contact between these components and the saw
blade could lead to dangerous situations.
e) Adjust the splitter in accordance with the description in
these operating instructions. Incorrect clearances, position
or alignment may be the reason why the splitter fails to prevent a
kickback eff ectively.
f) For the splitter to work, it must be engaged with the work-
piece. The splitter is ineff ective when cutting workpieces that are
too short to be engaged with the splitter. Under these conditions
a kickback cannot be prevented by the splitter.
g) Use the right saw blade for the splitter. For the splitter to
work properly, the saw blade diameter must match the splitter,
the saw plate of the saw blade must be thinner than the splitter
and the tooth pitch must be greater than the thickness of the
Anl_TC_TS_2225_U_SPK7_Rewe.indb 57
GB
- 57 -
24.03.2020 10:29:24