EINHELL TC-TS 2225 U Originalbetriebsanleitung Seite 74

of the saw table (1).
Then, using two recessed head screws (52) for each, secure the
•
table width extensions (33, 34) and the table length extension
(35) as shown in Figs. 5 and 6 to prevent them being pulled com-
pletely out.
Fit two locking screws (31) each to the left and right-hand sides
•
of the saw table (1) so that you can lock the table width extensi-
ons (33, 34) in a specific position.
Fit the two locking screws (32) to the back of the saw table (1) so
•
that you can lock the table length extension (35).
Important! A crosstip screwdriver is not supplied with the pro-
•
duct.
6.3 Standing the bench-type circular saw upright (2, 7-9)
Turn the machine over so that it stands on its legs.
•
The bench-type circular saw must be stood on a flat surface.
•
Then tighten all loose screw connections. Use both the wrenches
•
(38) and (39) to do this.
Screw the additional legs (37 to the rear legs (29) so that they
•
point towards the rear of the machine. Us the screws (54),
washers (49) and nuts (51) to fasten them.
Warning! Don not fit the additional legs (37) too far away from the
•
surface on which the machine stands; they are intended to provi-
de protection against tipping over.
Remove the screw (53) from the shaft (25).
•
Slide the hand wheel (8) and then the crank (10) onto the shaft
•
(25) as shown in Fig. 9.
Important! The shaft (25) and the crank (10) engage with a posi-
•
tive fit, i.e. the flat surface on the shaft (25) and the flat surface in
the hub of the crank (10) must lie on top of each other to enable
the crank (10) to be slid on.
Secure the hand wheel (8) and crank (10) with the screw (53).
•
Anl_TC_TS_2225_U_SPK7_Rewe.indb 74
GB
- 74 -
24.03.2020 10:29:26