EINHELL TC-TS 2225 U Originalbetriebsanleitung Seite 63

7. Faulty saw blades must be replaced immediately.
8. It must be possible for the blade to run freely.
9. Check the saw blade guard for damage and wear each time be-
fore using the saw.
10. The saw blade guard must lower again automatically under its
own weight after each cut. The saw blade guard must lift when
the workpiece is pushed in the direction of the saw blade.
11. Damaged or faulty safety devices have to be replaced immedia-
tely.
12.It is imperative to make sure that all devices which cover the saw
blade are in good working order.
13. Never dismantle the machine's safety devices or render them
inoperative.
14. Refi t all guards and safety devices immediately after you have
completed any repairs or maintenance work.
15. Keep the push stick or handle for a push block at the machine at
all times, even when you are not using them. Slot the push stick
or the push block into its holder when not in use.
16. The sawing of angles/wedges is only permitted if an appropriate
auxiliary stop (cross stop) is used.
17. If the table insert is worn, replace it. – Pull out the power plug –
18. If necessary, wear suitable personal protection equipment. This
could consist of:
a. Ear plugs to prevent the risk of damaging your hearing
b. A breathing mask to avoid the risk of inhaling hazardous dust
c. Always wear gloves when handling saw blades and rough ma-
terials. Whenever practicable, saw blades must be carried in a
container.
19. Use only the transport devices to move the equipment. Never
use the guards for handling or moving the equipment.
20. While you are moving the machine it is best to cover the top part
of the blade, e.g. with the guard.
21. Give these safety instructions to all persons who work on the
machine.
22. Do not use this saw to cut fi re wood.
Anl_TC_TS_2225_U_SPK7_Rewe.indb 63
GB
- 63 -
24.03.2020 10:29:25