EINHELL TC-TS 2225 U Originalbetriebsanleitung Seite 80

Undo the locking screw (20).
•
Turn the stop rail (24) until the arrow points to the angle required.
•
Re-tighten the fastening screw (20).
•
Check the gap between the stop rail (24) and the saw blade (4).
•
Warning! Do not push the stop rail (24) too far toward the blade.
•
The distance between the stop rail (24) and the blade (4) should
be approx. 2 cm.
If necessary, slacken the two knurled screws (43) and adjust the
•
stop rail (24).
Retighten the knurled screws (43).
•
7.5 Setting the angle of the saw blade (Fig. 16)
Undo the locking grip (9).
•
To adjust the angle of the saw blade, press the hand wheel (8)
•
towards the machine and turn it at the same time until the pointer
(41) is aligned with the desired angular setting on the scale (42).
Secure the locking grip (9) again.
•
If needed, the end stop for adjusting the angle of the saw blade
•
can be readjusted for 0° and 45°. To do this, adjust the two ad-
justment screws (44) and (45).
7.6 Adjusting the table width extensions (Fig. 8)
The table width extensions on the left (33) and right-hand sides
•
(34) on the saw table (1) can be extended outwards.
The pull-out width is limited by the recessed head screws (52)
•
(see 4. Technical data)
To lock the table width extensions (33, 34) in a specific position,
•
you can secure them with the locking screws (31).
If the parallel stop is used with the table width extensions exten-
•
ded, make sure that the parallel stop (7) lies against the guide
rail system (28) along the complete clamping width.
Danger! If the parallel stop (7) is not secured properly, this may
•
cause a kickback.
Warning! Whenever the table width extensions are extended,
•
always make sure that the workpiece lies safely on the saw table
Anl_TC_TS_2225_U_SPK7_Rewe.indb 80
GB
- 80 -
24.03.2020 10:29:26