EINHELL TC-TS 2225 U Originalbetriebsanleitung Seite 81

and cannot become jammed.
The table length extension (35) can be extended at the back and
•
is limited by screws (52) (see 4. Technical data)
To lock the table length extension (35) in a specific position, you
•
can secure it with the locking screws (32).
8. Operation
Warning!
After every new adjustment we recommend you to make a trial
•
cut in order to check the new settings.
After switching on the saw, wait for the blade to reach its maxi-
•
mum speed of rotation before commencing with the cut.
Take extra care when starting the cut!
•
Never use the equipment without the suction function.
•
Regularly check and clean the suction channels.
•
8.1 Making longitudinal cuts (Figure 21)
Longitudinal cutting (also known as slitting) is when you use the
saw to cut along the grain of the wood. Press one edge of the work-
piece against the parallel stop (7) while the fl at side lies on the
saw table (1). The guard hood (2) must always be lowered over the
workpiece.
When you make a longitudinal cut, never adopt a working position
that is in line with the cutting direction.
Set the parallel stop (7) in accordance with the workpiece height
•
and the desired width. (See 7.3.)
Switch on the saw.
•
Place your hands (with fingers closed) flat on the workpiece and
•
push the workpiece along the parallel stop (7) and into the blade
(4).
Guide at the side with your left or right hand (depending on the
•
position of the parallel stop) only as far as the front edge of the
guard hood.
Always push the workpiece through to the end of the splitter (5).
•
Anl_TC_TS_2225_U_SPK7_Rewe.indb 81
GB
- 81 -
24.03.2020 10:29:26