EINHELL TC-TS 2225 U Originalbetriebsanleitung Seite 69

Screw with washer and spring washer (4x)
•
Original operating instructions
•
Safety information
•
3. Proper use
The bench-type circular saw is designed for the slitting and cross-
cutting (only with the cross stop) of all types of timber commensu-
rate with the machine's size. The equipment is not to be used for
cutting any type of round wood.
The equipment is to be used only for its prescribed purpose. Any
other use is deemed to be a case of misuse. The user / operator
and not the manufacturer will be liable for any damage or injuries of
any kind caused as a result of this.
Please note that our equipment has not been designed for use in
commercial, trade or industrial applications. Our warranty will be vo-
ided if the machine is used in commercial, trade or industrial busi-
nesses or for equivalent purposes.
The equipment is to be operated only with suitable saw blades (saw
blades made of HM or CV) It is prohibited to use any type of HSS
saw blade and cutting-off wheel.
To use the equipment properly you must also observe the safety in-
formation, the assembly instructions and the operating instructions
to be found in this manual.
All persons who use and service the equipment have to be ac-
quainted with these operating instructions and must be informed
about the equipment's potential hazards. It is also imperative to ob-
serve the accident prevention regulations in force in your area. The
same applies for the general rules of health and safety at work.
The manufacturer will not be liable for any changes made to the
equipment nor for any damage resulting from such changes. Even
Anl_TC_TS_2225_U_SPK7_Rewe.indb 69
GB
- 69 -
24.03.2020 10:29:25