Using the crank (10) set the saw blade (4) to the maximum cut-
•
ting depth.
Remove the table insert (6) by undoing the countersunk head
•
screw (17) (see 6.4).
Remove the splitter (5) together with the saw blade guard (2)
•
(see 6.5).
Undo the screw (15) with a wrench (38) on the screw (15) itself
•
and a second wrench (39) on the motor shaft to apply counter-
pressure.
Caution! Turn the screw (15) in the direction of rotation of the saw
•
blade.
Take off the outer flange and pull the old saw blade (4) off the in-
•
ner flange.
Clean the blade flange thoroughly before fitting the new blade.
•
Fit and fasten the new saw blade (4) in reverse order.
•
Important! Note the running direction. The cutting angle of the
•
teeth must point in running direction, i.e. forwards (see the arrow
on the blade guard).
Refit and set the splitter (5) and the saw blade guard (2) (see
•
6.5.)
Check to make sure that all safety devices are properly mounted
•
and in good working condition before you begin working with the
saw again.
Warning! Every time that you change the saw blade, check that
•
the saw blade guard (2) opens and closes again in accordance
with requirements. Also check that the saw blade (4) spins freely
in the saw blade guard (2).
Warning! Every time that you change the saw blade (4), check to
•
see that it spins freely in the table insert (6) in both perpendicular
and 45° angle settings.
Warning! You should replace the table insert (6) immediately
•
whenever it is worn or damaged (see 6.4).
Warning! The work to change and align the saw blade (4) must
•
be carried out correctly.
Anl_TC_TS_2225_U_SPK7_Rewe.indb 76
GB
- 76 -
24.03.2020 10:29:26