F5 Disposal Of Packing; F6 Machine Positioning; F6.1 Fitting The Cable Holder; F6.2 Fitting Other Accessories - Electrolux LIBERO POINT NERLP2 Installations-Gebrauchs-Und Wartungs

panels without tearing it, to avoid leaving
traces of glue.
F5 Disposal of packing
All the packing materials are environmentally
friendly. They can be safely kept, recycled or
burned in an appropriate waste incineration
plant. Recyclable plastic parts are marked as
follows:
Polyethylene: o u t e r w r a p p i n g ,
instruction booklet bag.
PE
Polypropylene: roof packing panels,
straps.
PP
Polystyrene:
PS
The parts in wood and cardboard can be
disposed of, respecting the current regulations
in the country where the machine is used.
F6 Machine positioning
The appliance must be placed directly on the
fl oor where it will slide thanks to the wheels "L"
mounted in Zone E.
Make sure to block the wheels equipped with
brakes on the operator side before any work
on the machine and before commissioning.
F6.1 Fitting the cable holder
The appliance is equipped with an accessory
that facilitates gathering of the power cable
during moving and maintenance operations
(fi g. 1).
Fit the cable holder "T" on the side where the
control panel is:
Downloaded from www.Manualslib.com
corner protection.
ATTENTION!
It is advisable to place the
machine on a fl at fl oor.
ATTENTION!
Moving the appliance without
the constant supervision of a
qualifi ed operator is forbidden.
ATTENTION! ATTENTION!
Make sure the wheels with brakes Make sure the wheels with brakes
are properly blocked. are properly blocked.
manuals search engine
• Remove the plastic caps covering the
holes.
• Place the cable holder "
with the widest part downwards.
• Tighten the screws supplied, matching the
holes in the cable holder with those in the
side of the machine.
F6.2 Fitting other accessories
All accessories combinable with this appliance
are provided with installation instructions and
technical data.
F7 Installation diagrams
The installation diagrams (page 2) give the
machine's overall dimensions and the position
of electrical connections, the maximum height
of cooking pans, as well as the position of
the surround elements such as walls and any
fastenings.
The wall is represented in the diagrams with
the symbol:
F8 Electrical connection
Connection to the power supply must be
carried out in compliance with the regulations
and provisions in force in the country of use.
• Make sure the machine power supply voltage
given on the dataplate (Table 1) matches the
mains voltage;
• Make sure the system power supply is
arranged and able to take the actual current
load and that it is executed in a workmanlike
manner according to the regulations in force
in the country of use;
• In case of doubts regarding the effi ciency of the
equipotential ground connection, or aspects
concerning electrical safety, have the system
checked by a qualifi ed electrician;
F9 Grounding
This product must be connected to a metal
outlet, permanent wiring system, or to a
grounding device where the conductor must be
connected to the wires of the circuit and in turn
connected to the terminal, or to the appliance
grounding cable.
This product must be grounded. In case of
malfunction or fault, the grounding provides
42
T" against the side,