Dtechnical Data; D1 Main Technical Characteristics; D2 Power Supply Characteristics; Etransport, Handling And Storage - Electrolux LIBERO POINT NERLP2 Installations-Gebrauchs-Und Wartungs

D TECHNICAL DATA
D1 Main technical characteristics
For the general technical characteristics of
each "LIBERO POINT" model described
in this manual, refer to Table 1 - General
characteristics,
consumption.
D2 Power supply characteristics
The machine's AC power supply must meet
the following conditions:
• Max. voltage variation ±6%;
• Max. frequency variation ±1%;
Downloaded from www.Manualslib.com
performance
ATTENTION!
The machine's power supply
must be protected
overcurrents (short circuits and
overloads) by fuses or suitable
thermal-magnetic switches.
ATTENTION!
The protection rating against
water entering is: IP20.
For protection against indirect
contact (depending
type of power supply and the
connection of masses to the
equipotential protection circuit)
refer to point 6.3.3 of EN 60204-1
(IEC 60204-1) with the use of
protection devices that ensure
automatic disconnection of the
power supply in case of insulation
failure in TN or TT systems or, for
IT systems, the use of isolation
controllers or differential current
protection devices to activate
automatic power disconnection
(except when there a protection
device to disconnect the power
in case of a fi rst fault to ground,
an isolation controller
be provided to indicate the
occurrence of a fi rst fault by
an active part to the masses or
to ground. This device must
activate an audible and/or visual
signal which must continue for
the duration of the fault).
E.g. in a TT system, a differential
manuals search engine
switch with cut-in current (e.g.
30 mA) coordinated with the
grounding system of the building
where the machine is located
must be installed ahead of the
supply.
and
ATTENTION!
The
to follow these instructions,
otherwise the Manufacturer does
not guarantee the machine for
continuous
against faults.
E T R A N S P O R T , H A N D L I N G A N D
STORAGE
against
E1 Introduction
Transport (i.e. transfer of the machine from one
place to another) and handling (i.e. transfer
inside workplaces) must occur with the use of
appropriate and adequate means.
The machine can be transported by road, rail,
sea or air. Except for transport by road, the
machine is placed inside a container in which
there are also other machines. The machines
on the
can be placed inside the container by the
Manufacturer or by the forwarder.
ATTENTION!
Due to their size, the machines
cannot be stacked on top of
each other during transport; this
eliminates any risks of loads
tipping over due to stacking.
The Manufacturer declines any liability for
possible damage to the packages and the
machine.
On receiving the machine, check that the
packages and components are not damaged.
In case of damage, immediately notify the
carrier and inform the Manufacturer.
must
If the appliance received has visible or hidden
damage, a claim can be made with the
forwarder.
Visible losses or damage must be reported in
the transport document at the time of delivery.
The transport document must be signed by
the forwarder's representative (e.g. driver).
If the transport document is not signed, the
39
Customer is requested
operation and/or