E2.2 Shifting; E2.3 Placing The Load; E3 Storage; Finstallation And Assembly - Electrolux LIBERO POINT NERLP2 Installations-Gebrauchs-Und Wartungs

Before lifting:
• Send all operators to a safe position and
prevent people from entering the handling
area;
• Make sure the load is stable;
• Make sure no material can fall during lifting;
• Maneuver vertically in order to avoid
impacts;
• Handle the machine, keeping it at minimum
height from the ground.
E2.2 Shifting
The operator must: The operator must:
• • Have a general view of the path to be Have a general view of the path to be
followed; followed;
• • Stop the maneuver in case of hazardous Stop the maneuver in case of hazardous
situations; situations;
E2.3 Placing the load
Before placing the load, make sure the way is
free and that the fl oor is fl at and can take the
load.
E3 Storage
The machine and/or its parts must be stored
and protected against damp, in a non-
aggressive place free of vibrations and with
room temperature of between -10°C / 14°F
and 50°C / 122°F.
The place where the machine is stored must
have a fl at support surface in order to avoid
any twisting of the machine.
F INSTALLATION AND ASSEMBLY
Downloaded from www.Manualslib.com
ATTENTION!
For machine lifting, do not use
movable or weak parts such as:
fi lters, electrical cables, etc.
ATTENTION!
Machine installation,
maintenance and commissioning
operations must only be carried
out by specialized technicians
provided with all the necessary
PPE (e.g. safety
gloves, glasses, overalls, etc.),
equipment, tools and suitable
means.
manuals search engine
ATTENTION!
Make sure the main switch of the
panel the machine is connected
to is locked in the open "0" or off
position.
F1 Customer responsibilities
The customer must provide for:
• The installation of an adequate electrical power
supply ahead of the machine, as indicated in
the equipment technical characteristics (see
Table 1).
• Ducting for the electrical connection between
the workplace electrical panel and the
equipment;
• General workplace lighting to guarantee
at least 500 lx according to point 5.2.2 of
Standard EN 12464-1 or according to a value
established by the current regulations in the
country of use.
F2 Characteristics of the place of
machine installation
The machine is designed for installation in
professional-type (not domestic) kitchens,
canteens, showrooms, etc.
The machine is not suitable for built-in
installation.
F3 Machine space limits
A suitable space must be left around
the machine (for the outlet of fi ltered air,
operations, maintenance, etc.). The passages
for personnel having to work on the machine
must be at least 500 mm wide.
This distance must be increased in case of This distance must be increased in case of
use and/or transfer of other equipment and/or use and/or transfer of other equipment and/or
means, or if exit routes are necessary inside means, or if exit routes are necessary inside
the workplace. the workplace.
F4 Preliminary positioning
The machine is supplied in a single unit.
The machine must be taken to the place of
installation and removed from the packing
base only when being installed.
Arranging the machine:
shoes,
• Position the machine near the required place
or that described in the manual;
• Wear protective gloves and unpack the
machine;
• Carefully remove the protective fi lm from the
41