Setting The Alarm Clock; Using Multiple Handsets; Registering Handsets - Unify Gigaset S400 professional Bedienungsanleitung

Setting the alarm clock

Setting the alarm clock
Prerequisite: The date and time have
¢
already been set (
Activating/deactivating and setting the
alarm clock
á
¢ ¢
v
Alarm Clock
¤
You can enter data in the following
fields:
Activation:
Select On or Off.
Time:
Enter the wake-up time in 4-digit for-
mat.
How often:
Select or Monday-Friday.
Daily
Volume:
Set the volume (1–6).
Melody:
Select melody.
Press the display key.
§Save§
¼
In idle status, the
time are displayed.
A wake-up call is signalled on the display
and with the selected ringtone
¢
( page 3). The wake-up call sounds for
60 seconds. If no key is pressed, the wake-
up call is repeated twice at five minute
intervals and then switched off.
While the wake-up call sounds, you can
permanently change the volume by press-
ing the side keys ø (louder) or ÷ (qui-
eter).
During a call, the wake-up call is only sig-
nalled by a short tone.
Deactivating the wake-up call/
repeating after a pause (snooze mode)
Prerequisite: A wake-up call is sounding.
Press the display key. The
§OFF§
wake-up call is deactivated.
40
page 14).
icon and wake-up
or
Press the display key or any
§Snooze§
key. The wake-up call is deacti-
vated and then repeated after
5 minutes. After the second
repetition the wake-up call is
deactivated completely.

Using multiple handsets

Registering handsets

You can register up to six handsets to your
base.
A Gigaset S4 professional handset can be
registered on up to four bases.
Manually registering a
Gigaset S4 professional an
Gigaset S400 professional
You must activate manual registration of
the handset on both the handset and the
base.
When the registration process has com-
pleted successfully, the handset returns to
idle status. The handset's internal number
is shown in the display e.g.,
repeat the procedure.
On the handset
The handset is not registered to a base.
Press the display key.
§Register§
The handset is already registered to a
base:
Ï
¢ ¢
v
Registration
¢
Register Handset
If the handset is already registered to four
bases:
s
Select base, e.g.,
press
§OK§
~
If required, enter the system
PIN for the base and press
INT 1. If not,
and
Base 3
.
§OK§
.