Setting Up; Switching On And Off; Changing The Direction Of Rotation; Fitting A Socket - Parkside PDSSE 550 A1 Originalbetriebsanleitung

Setting up

WARNING!
► Switch the appliance off and remove the
power plug 4 before starting any work on
the appliance .

Switching on and off

Switching on
♦ Press the ON/OFF switch 3 to start the
appliance .
The appliance starts at maximum speed .
■ The tightening torque depends on the impact
duration .
Switching off
♦ Release the ON/OFF switch 3 to switch off the
appliance .
ATTENTION!
♦ The tightening torque actually attained must
always be checked with a torque wrench!

Changing the direction of rotation

WARNING!
► The rotation direction switch 1 may only be
used/adjusted when the appliance is at a
standstill .
♦ Change the direction of rotation by pressing the
rotation direction switch 1 towards the left or
right .
NOTE
► In clockwise rotation, the maximum torque is
limited to 100 Nm .

Fitting a socket

♦ Push one of the supplied sockets 7 onto the
tool holder 5 .
■ 6 │
GB

Maintenance and cleaning

WARNING! RISK OF INJURY! Switch
the appliance off and remove the
power plug 4 before starting any
work on the appliance.
The appliance is maintenance-free .
■ The appliance must always be kept clean, dry
and free from oil or grease .
■ Never permit liquids to enter inside the appli-
ance .
■ Use a soft, dry cloth to clean the housing .
Never use petrol, solvents or cleansers which
can damage plastic .
■ Only the service centre or a recognised
specialist workshop is qualified to exchange
the replacement carbon brushes 6 via the
maintenance cover 2 .
■ Never obstruct the ventilation openings .
■ Store the appliance in a dry place .
WARNING!
► If the mains cable needs to be replaced, this
must be carried out by the manufacturer or
an authorised representative in order to avoid
safety hazards .
NOTE
► Replacement parts not listed (such as carbon
brushes, switch) can be ordered via our
service hotline .
PDSSE 550 A1