Assembly Instruction - SPORTSTECH SX100 Speedbike Benutzerhandbuch

Preparation
A. Before assembling make sure that you will have enough space around the item.
B. Use the present tooling for assembling.
C. Before assembling please check whether all needed parts are available (at the above of this instruction sheet).
you will find an explosion drawing with all single parts (marked with numbers) which this item consists of.

Assembly Instruction:

1
2
2) ASSEMBLY INSTRUCTION
1.2
2.2
21
1)
Connect the front tube with the frame, and
install the plain washer Ø10, washer 10
to the bolts and put on the cover-shaped
screws. And use open spanner to fasten
them. Installation of back tube is the same.
Note: Please adjust the black feet strap to make it
balance if it is not stable.
2)
The feet straps are marked with L and R.
Please drop 2 red screw locking liquid in
R strap and fasten it with right threaded
hole by using our spanner. And drop 2 red
screw locking liquid in L strap and fasten it
with left threaded hole.
Note: L and R are marked in crank as well. Please
install them accordingly otherwise it will damage
the products. And please fasten the feet strap, or
it will fall down after long usage.