Cleaning and maintenance
42/60
Downloaded from
www.Manualslib.com
5.5
5.5.1
–
Inspect the device for leaks.
5.5.2
The tank must be vented 3 days after commissioning or after it has been
initially filled. After this, venting is unnecessary unless leakages occur and the
tank has to be topped up.
–
Open the valve.
–
Press the rubber blanket down gently, so that the air escapes.
–
Shut the valve again afterwards.
manuals search engine
Maintenance performed by the
operator
Daily visual inspection
WARNING!
The device might be damaged by moisture!
–
The device may no longer be used in the event of water
loss (puddles on the floor). Please inform our customer
service department – see page 2.
–
Do not switch the device on if there are leaks or if it is
damaged. Inform our customer service department –
see page 2.
Venting
DANGER!
Illnesses can be caused by contaminated water!
The water in the tank is untreated and can be contaminated
with bacteria.
–
Wear protective gloves if you are likely to come into
contact with the water.