eta FALCO SMART Bedienungsanleitung Seite 67

EN
Spot mode
This mode is applicable for an area of highly concentrated dirt or dust. In spot cleaning
mode, robot focus on one area for cleaning.
Click the button B4 on robot or F6 on remote control to start Spot mode.
Cleaning takes about 1:50 min. and when it is finished robot stay on palce, where finished
cleaning.
Edge mode
This mode is good for cleaning the edges and corners of a room. In edge cleaning mode,
robot runs along a border (e.g. wall). Under this mode, the robot will go back to the
charging base once cleaning finished.
Click the button F7 on remote control to start Edge mode.
Setting of suction power
This setting is for the overall dirty floor, dusty circumstances. It is possible under Auto,
Systematic or Edge mode. Press F4 on remote control, display panel will show HI: high-
end mode, which will increase the suction power for deep cleaning. Press key F4 again to
change to normal suction LO: low-end mode.
EN - 67