eta FALCO SMART Bedienungsanleitung Seite 77

Reason
07 Cliff sensor
abnormal
08 Front bumper
abnormal
09 The robot
get stuck
10 Fan abnormal
11 Water tank
abnormal
12 Battery abnormal
13 Anti-bump sensor
modules abnor-
mal
14 Gyro navigation
module abnormal
15 Low battery
16 High-performance
filter blocked
During product use process, if encounter following problems, you can check below table to
solve.
Problem
01 Robot cannot
be charged
Display Prompt
Panel Tone
E22
E42
E31
E32
E33
E41
E42
E43
LO
Reason
Robot is not fully connecting
the charging pin of charge
base
Charge base power is turned
off, and robot is turned on,
which cause power
consumption
EN - 77
2 Check cliff sensor
2 Check front bumper
3 Move robot to open place,
and restart it
3 Please restart robot. If problem
is not solving, please contact
our after-sales staff
3 Check water tank if been
installed properly
3 Check the charging station or
change battery
4 Please restart robot. If problem
is not solving, please contact our
after-sales staff
5 Please restart robot. If problem
is not solving, please contact our
after-sales staff
/ Please operate the robot back
to charging base via remote
control. When robot is on
standby, make sure it is
charged so that it has enough
power to work at any time
/ Clean high-performance filter
Ensure robot and charging
pin of charge base are fully
connecting
It is recommended to keep
charging when robot not
work, in order to have enough
power for next cleaning
Solutions
Solutions
EN