Disposal - Parkside PDFP 500 C3 Originalbetriebsanleitung

■ After every use, squirt thinners (only outside –
risk of explosion!) or water through the appli-
ance.
♦ To clean the housing, the nozzle head
the spray holes inside it, use the supplied
cleaning brush or a cloth. Never use petrol,
solvents or cleansers which can damage plastic.
♦ First, unscrew the stroke limiter screw
turning it in an anticlockwise
♦ Remove the spring
♦ Remove the needle
♦ Clean the needle
(see fig. B).
♦ Replace the needle
♦ Push the spring onto the end of the
needle .
♦ Screw the stroke limiter screw
it clockwise .
♦ Screw the flow cup
spray gun.
♦ Remove the filter
clean it with the cleaning brush.
♦ Also clean the screw thread
cup using the cleaning brush (see fig. D).
♦ Replay the filter in the spray gun (see fig. C)
and screw the flow cup
onto it.
♦ For rust protection purposes, you can spray a
little sewing machine oil through the spray gun
after cleaning.
♦ Oil all moving parts from time to time.
♦ After cleaning the needle, the thread and seal
must be lightly greased with a suitable lubricant.
♦ Do not use any silicon-based lubricants.
♦ Store compressed-air appliances only in dry
rooms.
PDFP 500 C3
and
by
direction.
.
using pliers (see fig. A).
carefully with the brush
in the paint spray gun.
tight by turning
anticlockwise off the
as shown in fig. C and
of the flow
clockwise firmly

Disposal

The packaging consists of environ-
mentally friendly material. It can be
disposed of in the local recycling
containers.
Your local community or municipal authorities can
provide information on how to dispose of the
worn-out appliance.
Dispose of the packaging in an
environmentally friendly manner.
Note the labelling on the packaging
and separate the packaging material
components for disposal if necessary. The pack-
aging material is labelled with abbreviations (a)
and numbers (b) with the following meanings:
1–7: Plastics, 20–22: Paper and cardboard,
80–98: Composites.
Your local community or municipal
authorities can provide information on
how to dispose of the worn-out
product.
The product is recyclable, subject to
extended producer responsibility and
is collected separately.
Environmental compatibility and material
disposal
■ Paints and lacquers... are considered special
waste which must be disposed of accordingly.
■ Observe the local regulations.
■ Observe the manufacturer's instructions.
■ Environmentally harmful chemicals must not be
allowed to get into the ground, groundwater or
any body of water.
■ Spraying work next to bodies of water or
adjoining surfaces thereof (catchment basin) is
therefore not permitted.
■ When buying paints, lacquers... pay attention
to their environmental compatibility.
GB │ IE │
17 ■